Sultana build log – Part 44

The design and 3D printing of parts continues. This time, it’s the channels. After some experimentation, I made them a little bit larger than what appears on the plans. The tabs were added as an aid in attaching them to the hull.

3D design of the channels

Here are the pieces after printing.

3D printed channels

I also printed long strips, 1mm x 1mm, to use as the trim. Note how the channels and trim are merged.

Channels attached to the model
Channels attached to the model

Leave a Reply

Your e-mail address will not be published. To prevent spam, URLs are forbidden in comments.